SG-TW10 / 010-02103-00
Signature Series 330 Watt Component Tweeters
$99.99USD
$99.99USD
Signature Series 330 Watt Component Tweeters
SG-TW10 $99.99USD
Features
Search Help Topics
We didn't find any results for the search
FAQs
My Fusion system has a loud hum or noise coming from the speakers connected to my amplifier.
This is normally caused by introduced interference through the RCA cables connected from the stereo to the amplifier and is often referred to as a ground loop. It can be caused by numerous electric sources of interference such as refrigerators, power and ground cables, LED lights etc. You can spend a lot of time searching for the source, so prevention is the best course - do not run RCA cables near any electrical equipment or power/ground cable runs.
The quickest way to resolve this is by fitting ground loop isolators on all RCA cables - this is an inexpensive way to remove the unwanted noise.
How do I connect wiring to my Signature Series Sport speaker for LED lighting?
Sports Model LED Wiring
Connecting the LED wires to the Sports model speakers (Note: This feature is available only on the Sports model speakers - you can control the color of the LEDs by the polarity of the LED wires)
- Using the hex key, loosen the screws on the wiring terminals on the back of the speaker.
- Connect the black and red wires to the terminal according to the preferred LED color.
- Blue: black wire to negative (-) and red wire to positive (+)
- White: black wire to positive (+) and red wire to negative (-)
- Using the hex key, tighten the screws on the wiring terminals.
- Push the wire into a retaining clip to relieve the tension on the wire.
Connecting the Sports model speakers' LED wires to power (Note: This feature is available only on the Sports model speakers)
All 12VDC wiring to the LEDs must be fused at the power source end of your cable using a 3A fuse. The red power (+) wire should be connected to a 12VDC source through an isolator switch or circuit breaker to turn the speaker LEDs on and off. You can use the same isolator or circuit breaker controlling the power supply to your stereo, which allows you to turn the LEDs and stereo on and off at the same time. If it is necessary to extend the red and black wires include with the speakers, you should use 20 AWG (0.5 mm2) or thicker wire.
- Route the red power (+) and black ground (-) wires to the battery and speaker.
- Connect the black wire to the negative (-) battery terminal.
- Connect the red wire to the positive (+) terminal through a 3A fuse and isolator switch or circuit breaker.
Are the Signature Series Classic grilles available as a spare part?
Yes, the Classic White grilles are setup as a spare part therefore your local Fusion dealer will be able to order this in for you.
To find your local dealer visit our Where To Buy section.
Are the Signature Sports grilles removable?
Unfortunately, due to the fact the LED lighting and tweeter are mounted within the grille, they cannot be removed.
Videos
Articles
New Support Request
Sending...
Delivery Failed
Your message could not be delivered due to an error. Please resolve the issues below or contact us directly.
Error Details
Error Details Explanation Text
Register Product
Sending...
Success
Thank you, your products have been registered. You will receive a confirmation email shortly.
Back to Form
Delivery Failed
We could not register your products due to an error. Please resolve the issues below or contact us directly.
Error Details
Error Details Explanation Text
Add another dimension to your music with a new component tweeter.
Gone are the days of your audio being compromised by limited speaker placement options and engine noise! It is often difficult to find the space for optimal speaker placement, which results in installations where speakers are mounted low, close to the floor - limiting the amount of high frequency audio that can be heard when standing.
Cue the compact Signature Series tweeters, to restore the high frequencies for an audible improvement in sound quality on board. Install the compact tweeters in higher locations such as the dash or window/windscreen support frames to enjoy enhanced audio quality on your RV.
Each tweeter produces an impressive 330 watts peak power with a 1” voice coil, neodymium pot magnet system and aluminum tweeter dome for quality high frequency detail in your music.
The perfect complement for Fusion’s Signature Series speakers and DSP-enabled stereos, like the Apollo Series, these tweeters are designed to enhance the audio reproduction for a truly spectacular musical experience on your RV.
Features:
Add Another Dimension to Your Music – Bring the high frequency audio delivery back to ear level to add another dimension to your on-board audio. There’s now no need to compromise on sound quality with speaker placement or engine noise!
Compact Performance – Working in unison, the 1” voice coil, neodymium pot magnet system, aluminum tweeter dome and an impressive 330 watts peak power produce quality high frequency detail, all from a compact form factor.
The Perfect Complement – Designed and optimized to perfectly complement your Signature Series speakers, these tweeters will enhance the audio reproduction when integrated with the Signature Series and Fusion DSP-enabled stereos. A class D Stereo or amplifier that supports a minimum of 2 Ohms impedance per channel is required.
IP65 Weatherproof – Perfect for installation both indoors and outdoors, you don’t need to worry about your tweeters not lasting on your RV, with an IP65 rating for protection against water and dust ingress from the front face.
Flush Mount with a Low Profile – Quick, easy, versatile and cost-effective to install, these compact tweeters also feature a low profile to reduce the risk of damage from people or objects passing by.
Add Another Dimension to Your Music
Now there is no need to compromise on audio quality with limited speaker placement options and engine noise! Designed to add directional high frequency detail to your music, these tweeters add another dimension for crisp, clear high frequency audio like never before.
The Perfect Complement
Designed to perfectly complement the acoustics of the Signature Series speakers, these tweeters will enhance the audio reproduction on your RV when integrated into a system with the Signature Series speakers and a Fusion DSP-enabled stereo.
A Signature Performance
Working in unison to produce spectacular high frequency detail in your music, each Signature Series tweeter combines a 1” voice coil, neodymium pot magnet system and an aluminum dome tweeter with an impressive 330 watts peak power for a signature performance.
IP65 Weatherproof
Install your Signature Series tweeters where they are most convenient on your RV, without the worry of water or dust damage. With their IP65 weatherproof rating from the front face, these tweeters are perfect for either indoor or outdoor installation.
The Outdoor-Ready™ Standard
As an Outdoor-Ready product, the Signature Series tweeters are designed and engineered for harsh outdoor environments. Once a product has been subject to rigorous environmental testing and passed our stringent Outdoor-Ready approval process, it is awarded the accreditation and recognized with an industry-leading 3-year consumer warranty.
Are you ready to experience the power of music?
WHERE TO BUYRelated Products
Are you ready for the new era of marine audio entertainment?
Request a Quote
Please select a product
Closest Stores
Loading ...
No stores found.
Your Details:
Request a Quote
Get a quote from your nearest FUSION dealer
Request Sent
We've sent you a confirmation email.
You should hear back from these dealers shortly.
Product Specifications
| Peak Power | 330 Watts |
|---|---|
| RMS Power Rating | 60 Watts |
| Efficiency (1W/1M) | 91 dB |
| Frequency Response | 3 kHz - 20 kHz |
| Impedance | 4 Ohms nominal |
| Impedance when connected to a Signature Series speaker | 2 Ohms nominal |
| Voice Coil Diameter | 1" |
| Tweeter Type | Aluminum Hard Dome |
| Mounting Diameter Clearance | 51mm (2") |
| Mounting Depth Clearance | 31mm (1-1/4") |
| Tweeter Depth | 28.4mm (1-1/8") |
| Tweeter Dimensions: Length x Height x Depth | Ø 74mm x 28mm [Ø 2-15/16" x 1-1/8"] |
| Warranty | 3 years |
