8.8" 330 Watt Coaxial Wake Tower Sports Chrome & White Marine Speakers with LEDs

SG-FT88SPWC

SG-FT88SPWC $999.99USD

Manuals & Downloads

Installation Instructions

  • Installation Instructions (1.269 MB PDF) Download
  • 2 in. NPS Bracket Installation Instructions (3.347 MB PDF) Download

Warranty & Compliance

  • Important Safety & Product Information (176.327 kB PDF) Download

We didn't find any results for the search

FAQs

My Fusion system has a loud hum or noise coming from the speakers connected to my amplifier.

This is normally caused by introduced interference through the RCA cables connected from the stereo to the amplifier and is often referred to as a ground loop. It can be caused by numerous electric sources of interference such as refrigerators, power and ground cables, LED lights etc. You can spend a lot of time searching for the source, so prevention is the best course - do not run RCA cables near any electrical equipment or power/ground cable runs.

The quickest way to resolve this is by fitting ground loop isolators on all RCA cables - this is an inexpensive way to remove the unwanted noise.

How do I connect wiring to my Signature Series Sport speaker for LED lighting?

Sports Model LED Wiring

Connecting the LED wires to the Sports model speakers (Note: This feature is available only on the Sports model speakers - you can control the color of the LEDs by the polarity of the LED wires)

  1. Using the hex key, loosen the screws on the wiring terminals on the back of the speaker.
  2. Connect the black and red wires to the terminal according to the preferred LED color.
    1. Blue: black wire to negative (-) and red wire to positive (+)
    2. White: black wire to positive (+) and red wire to negative (-)
  3. Using the hex key, tighten the screws on the wiring terminals.
  4. Push the wire into a retaining clip to relieve the tension on the wire.

Connecting the Sports model speakers' LED wires to power (Note: This feature is available only on the Sports model speakers)

All 12VDC wiring to the LEDs must be fused at the power source end of your cable using a 3A fuse. The red power (+) wire should be connected to a 12VDC source through an isolator switch or circuit breaker to turn the speaker LEDs on and off. You can use the same isolator or circuit breaker controlling the power supply to your stereo, which allows you to turn the LEDs and stereo on and off at the same time. If it is necessary to extend the red and black wires include with the speakers, you should use 20 AWG (0.5 mm2) or thicker wire.

  1. Route the red power (+) and black ground (-) wires to the battery and speaker.
  2. Connect the black wire to the negative (-) battery terminal.
  3. Connect the red wire to the positive (+) terminal through a 3A fuse and isolator switch or circuit breaker.

Are the Signature Series Classic grilles available as a spare part?

Yes, the Classic White grilles are setup as a spare part therefore your local Fusion dealer will be able to order this in for you.

To find your local dealer visit our Where To Buy section.

Are the Signature Sports grilles removable?

Unfortunately, due to the fact the LED lighting and tweeter are mounted within the grille, they cannot be removed.

Videos

Articles

New Support Request

Sending...

Success

Thank you for your enquiry. A Fusion team member will contact you.

Back to Form
How will this be used?

We use your name to help verify your registered products when you call customer support, or to communicate with you about your transactions or products. You do not need to provide your full name, but you may if you wish.

Please fill out your email

How will this be used?

We require an email address to contact you in response to your enquiry. We use it to help verify your request when you contact Fusion Entertainment, or to communicate with you about your request, transactions or products. With your consent, we may use it to send you news and special offers.

Please fill out your phone number

How will this be used?

We require your phone number to contact you in response to your enquiry and to help verify your products for customer support.

Please select a region

How will this be used?

We require the region you live in to efficiently identify which support team you will be referred to if further support is required. If you have opted in to email marketing, we will use this information to provide you with emails relevant to your region.

Please enter a serial number

How will this be used?

We require the serial number to identify exactly which product you have purchased to efficiently and effectively assist with your product query.

Please enter the software version

How will this be used?

We require the software version to identify which version your product is operating on to efficiently and effectively assist with your product query.

Please enter date of purchase

How will this be used?

We require the date of purchase to verify whether or not your product is under warranty.

Add Address Details

Your address is only required if you are submitting an RMA and need the product sent back to you.

Please select a country

Your address is only required if you are submitting an RMA and need the product sent back to you.

Please fill out a message

How will this be used?

We require a description of your question or issue to help you with your product enquiry.

Please fill out the verification

View our privacy policy

Register Product

Personal Details

How will this be used?

We use your name to help verify your registered products when you call customer support, or to communicate with you about your transactions or products. You do not need to provide your full name, but you may if you wish.

Please fill out your email

How will this be used?

We require an email address to contact you in response to your enquiry. We use it to help verify your request when you contact Fusion Entertainment, or to communicate with you about your request, transactions or products. With your consent, we may use it to send you news and special offers.

Please select a region

How will this be used?

We require the region you live in to efficiently identify which support team you will be referred to if further support is required. If you have opted in to email marketing, we will use this information to provide you with emails relevant to your region.

Product Details

Please fill out the serial number

How will this be used?

We require the serial number to identify exactly which product you have purchased to efficiently and effectively assist with your product query.

How will this be used?

We require a description of any additional details or questions you have to help you with your product further.

Please fill out the verification

View our privacy policy

Sending...

Success

Thank you, your products have been registered. You will receive a confirmation email shortly.

Back to Form

The wake tower speakers are designed to deliver crystal clear, high performance audio at all volume levels.

For those serious about their sounds while enjoying high speeds on the water, the Signature Series Wake Tower speakers deliver it all.

Acoustically optimized and engineered for quality audio at any volume level, these speakers are perfect for providing the soundtrack to your on-water antics – even at full speed. Like the original Signature Series, the Wake Tower speakers are pushing the boundaries of what is possible on the water even further, with unparalleled performance in the harsh marine environment.

Precisely calculated for exceptional sound reproduction, the enclosure is designed with the exact air volume required for premium audio at any volume you choose to enhance your on-water experience.

A dedication to perfection and a commitment to developing new technologies – this is our mark, this is our Signature.

Features:

Precisely Calculated Enclosure – Designed with the exact air volume required for exceptional sound reproduction at any volume level, the Signature Series Wake Tower Speakers are optimized for wake boat applications.

CURV Cone Technology – CURV woven fiber composite is heat pressed to form a lighter and stronger cone that delivers improved sound definition and higher output, while also providing increased protection from the marine conditions.

Fully Sealed Crossover Components – Provides full protection from the harsh marine environment, whilst delivering an improved frequency response at the crossover point for a detailed audio spectrum and new level of acoustic performance.

Silk Dome Tweeter – Creates a smooth upper frequency response and increased efficiency, which delivers crystal clear music reproduction.

Large Diameter Voice Coil – Delivering an increase in real power and efficiency, the voice coil provides a signature sound exclusive to the 8.8” Wake Tower Speakers.

IP65 Weatherproof – Rated IP65 for water and dust ingress protection while also meeting industry standards for UV and salt fog protection, these speakers are engineered for tower installation on any vessel in the marine environment.

Premium Sports Aesthetic – Seamlessly integrate your Wake Tower Speakers with any sports boat. Incorporating premium materials and marine-specific design elements for a stylish system that reproduces quality audio and delivers it loud, the Signature Series Wake Tower Speakers are perfect for your sports or wake boat.

The Power of Music

The Signature Series is created by some of the finest design and engineering minds in the industry, with an unwavering vision of creating exceptional audio systems for those seeking a superior listening experience. Designed by musicians and engineered by boaties, the Signature Series is a fusion of these two fundamentals that feels right at home on the water. A dedication to perfection and a commitment to developing new technologies – this is our mark, this is our Signature.

Exceptional Audio for Your Wake Boat

Resulting in a truly immersive, acoustically stunning musical experience, the Wake Tower Speakers are engineered for exceptional sound reproduction. Precisely calculated speaker enclosures are designed with optimum air volumes to ensure quality audio at any volume level – even at full speed.

Mounting Brackets are available (sold separately) to install your speakers. Choose from the Universal Fixed, Universal Swivel or 2" NPS Wake Tower Mounting Brackets.

Superior Performance at Any Volume Level

CURV Cone Technology is an innovative engineering process that has created a superior-performance composite cone that delivers premium audio reproduction. CURV is a tough and abrasion-resistant material that is 30% lighter than mica-filled polypropylene at equal stiffness, matched with superior durability and high resistance to moisture, UV and temperatures. CURV is the only option for the Fusion Signature Series speakers.

A Harmony of High Quality Engineering

Silk Dome Tweeter

The silk dome tweeter provides a smooth upper frequency response to the sound stage of the Signature Series speakers. Matched with the increased efficiency of the high grade materials used in the speaker design, the silk dome tweeter plays a critical role in delivering a true symphony to the ears.

CURV Cone Technology

CURV Cone Technology is an innovative engineering process that has created a superior-performance polypropylene composite cone that delivers premium audio reproduction. CURV is a tough and abrasion-resistant material that is 30% lighter than mica-filled polypropylene at equal stiffness, matched with superior durability and high resistance to moisture, UV and temperatures, it is the only option for the Signature Series speakers.

Fully Sealed Crossover Components

All crossover components are sealed, resulting in enhanced protection from the harsh outdoor and marine environment. The crossover design delivers improved frequency response at the crossover point for a detailed spectrum of audio and a new level of acoustic performance.

Large Diameter Voice Coil

Delivering an increase in power and efficiency, the round wound copper voice coil provides a signature sound exclusive to the Signature Series speakers.

High Grade Engineered Basket Construction

The attention to detail highlights the built-for-purpose philosophy of the Signature Series speakers. With strain-relief clips for wiring, gold-plated terminals and screw tight wire fasteners, the basket housing is truly thought out to ensure high quality delivery of audio. Understanding the environment the Signature Series will live in, high grade engineered plastics are utilized to provide optimal protection from the outdoor and marine environment.

Energize Your Boating Experience

Get the party started with dual-color diffused LED lighting in either Striking Blue or Sparkling White on your Signature Series Wake Tower speakers. Note: Color is determined by wiring polarity at installation.

The True-Marine Standard

As a True-Marine product, the Signature Series marine speakers are designed and engineered for the harsh marine environment. Once a product has been subject to rigorous environmental testing and passed our stringent True-Marine approval process, it is awarded the accreditation and recognized with an industry-leading 3 year consumer warranty.

IP65 Weatherproof

Every Signature Series marine speaker undergoes extensive environmental testing for ingress protection, ensuring they are prepared for the marine environment. Rated IP65 for water and dust protection, while also meeting industry standards for UV and salt fog protection, the Signature Series Wake Tower speakers are perfect for tower installation on any vessel.

Are you ready to experience the power of music?

WHERE TO BUY

Related Products

Product Specifications

Configuration Coaxial
RMS Power Rating 130 watts
Peak Power 330 watts
Tweeter Type Silk Dome
Cone Material CURV
Efficiency (1W/1M) 91dB
Frequency Response 55 Hz - 25 kHz
Impedance 4 Ohms
Speaker and LED Cable (Without Terminal) 610mm (2')
Voice Coil Diameter 1.5"
LED Color Options White and Blue
LED Supply Voltage From 10.8 to 16 Vdc
LED Load Current at 14.4 Vdc 150 mA
Enclosure Diameter 224mm (8-13/16")
Enclosure Depth 381mm (15")
Height Including Mounting Clamp (sold separately) 241mm (9-1/2")