Current consumption of Fusion Marine stereos
MS-650/750 and all future marine stereos have the voltage rating of 10.8V to 16V DC.
All figures are for head units only. Amplifiers will contribute significantly higher current consumptions
All marine stereos with 4 Amplified speaker outputs were tested with 4 speakers attached. No USB devices connected.
All measurements are average and so measurements on other production stereos may vary.
Go to the settings menu and select “set device name” Enter the name and press play to save. This is very useful when you multiple stereo’s on the network or for Bluetooth pairing.
Go to the settings menu and select “stereo” then select the stereo from the list of Fusion stereo’s on the network.
The NRX200i Remote is rated LEN:3
Press the power on/off button (short press). Press again to unmute.
The remote software is embedded in the Fusion Headunit software, go to the settings menu select update and then select NRX200. The remote (or remotes) that are connected and powered on will be updated and the progress will be displayed on both the head unit and remote. Do not remove power during this operation as it can cause the remote to become non operational.
Whilst in NMEA mode simply press the source button to cycle supported available devices on the network.
Simply press and hold the source button until the NMEA screen is displayed . To return to the Audio mode simply press the menu button.
Care and Maintenance MS-WR600 remote
As with all products with a chrome finish exposed to the harsh Marine environment, a little care will help to preserve the finish and prevent corrosion. Fusion recommends that you clean any salt water and/or salt residue from the remote with a damp cloth soaked in fresh water. Always fit the protective cover when not in use.
To assign your remote to a specific Zone, follow these simple steps. Press and hold the ‘Mute’ button ‘ for 5-6 seconds until the menu appears. Select ‘Assign Zone’.
Select the Zone/s you wish to assign (Zone 1-2-3 or Zone 123 all) to the remote and confirm by pressing the Rotary Encoder
Press the Menu button to exit. Turn the remote off and re start the unit.